Alfa Romeo Giulia Forum banner
1 - 4 of 4 Posts

·
Vendor
Joined
·
1,200 Posts
Discussion Starter · #1 · (Edited)
Have you been looking to upgrade the exterior of your Alfa Romeo Giulia?

If so than you have come to the right place!

The demand for Carbon Fiber for Giulia has been significant and due to that we have been continuously adding new Carbon Fiber Products and investing more in to inventory to reduce wait times!

We recently received a shipment of these Vent Covers and could not help ourselves and ended up installing them on our own Giulia.

These air vent covers are made out of the Delta-Preg Prepreg Carbon Fiber and fit great. We installed them on our car using a two part epoxy, but you can use silicone or even thin double side tape. The fitment is just about perfect and the set of four (front and rear vents) really pop in the interior.

This along with many other carbon items are now in stock and available. More carbon pics to come!





For more information on this product please follow the link below:

https://madnessautoworks.com/2017-A...o-giulia-air-vent-covers-carbon-fiber-pid6090

As always any questions please do not hesitate to reach out. If you plan on ordering 3 or more items give us a buzz and we will do our best to sharpen our pencil and save you a little on either the parts or the shipping.
 

·
Vendor
Joined
·
1,200 Posts
Discussion Starter · #2 ·

·
Registered
Joined
·
1,807 Posts
Snap on or adhesive

Do these snap on or rely on adhesive or require removal of factory trim piece...?
 

·
Vendor
Joined
·
1,200 Posts
Discussion Starter · #4 · (Edited)
These fit directly over the factory parts and can be either epoxied in place or you can use thin double side tape.

Install was pretty simple. We used adhesive and then Blue Painters Tape to keep them in place until the epoxy cured (overnight).
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top